New Falling Film Reactor for Melt Polycondensation Process

Summary: A grid falling film tower (GFFT) has been invented as an ideal polycondensation reactor. In this reactor, polymer melt flows through multi-layers grids from top to bottom to form falling film owing to gravity without agitation and shear; large gas-liquid interfacial area is generated; the grids are perpendicular between adjacent layers to ensure film renewal and to achieve uniformly flowing. The fluid flow in this reactor has little back-mixing and dead zone, which is near to plug flow. All melts are under the state of thin film which avoids the negative effect of hydrostatic head on the mass transfer impetus. Furthermore, the GFFT has wide operation flexibility as well as adjustable configuration parameters to meet different demands. A pilot scale GFFT with the height of 4.0 meters has been applied to polyester polycondensation process. The intrinsic viscosity of polyethylene terephthalate increased from 0.45 dl/g to 0.8–0.9 dl/g successfully. GFFT is supposed to be an universal apparatus for many devolatilization processes.     

缓冲层ZnPc对有机电致发光器件特性的影响

本文研究了酞菁锌(ZnPc)薄膜的表面形貌及ZnPc薄膜作为缓冲层对有机电致发光器件(OLEDs)光电特性的影响.对比两组样品的AFM图像,ZnPc薄膜相比于ITO薄膜,其表面的岛面积较大,薄膜表面更连续平整,基本上覆盖了ITO膜表面针孔,减少了表面的缺陷.另外,ZnPc薄膜的岛分布均匀有序.使用ZnPc作为缓冲层的器件性能明显好于未使用ZnPc修饰的器件,在7.42V的驱动电压下的最大发光亮度达到1.428kcd/m2,在4.3V电压驱动下时,最大光功率效率为1.411m/W;而未使用缓冲层的器件在8V的驱动电压下达到最大发光亮度达到1.212kcd/m2,在5.5V电压驱动下时,最大光功率效率为0.931m/W.     

Anchoring properties of substrate with a grating surface

The anchoring properties of substrate with a grating surface are investigated analytically. The alignment of nematic liquid crystal (NLC) in a grating surface originates from two mechanisms, thus the anchoring energy consists of two parts. One originates from the interaction potential between NLC molecules and the molecules on the substrate surface, and the other stems from the increased elastic strain energy. Based on the two mechanisms, the expression of anchoring energy per unit area of a projected plane of this grating surface is deduced and called the equivalent anchoring energy formula. Both the strength and the easy direction of equivalent anchoring energy are a function of the geometrical parameters (amplitude and pitch) of a grating surface. By using this formula, the grating surface can be replaced by its projected plane and its anchoring properties can be described by the equivalent anchoring energy formula.     

Atomic coherence in nondegenerate four-wave mixing

Two-photon resonant nondegenerate four-wave mixing (NFWM) with the addition of a coupling field in Ba atomic vapour has been studied. We find that coherence of the atomic level transitions leads to suppression of the NFWM signal, giving rise to a dip with a linewidth that is linearly proportional to the intensity of the coupling field.     

Inversionless gain enhancing due to Doppler broadening in a closed lambda-type system

An analysis is made of the effect of Doppler broadening on gain without inversion (GWI) from different aspects in a closed lambda-type three-level system with an incoherent pump. It is shown that, regardless of the driving field being on resonance or not, for the counter- or co-propagating of the probe and driving fields (PDF), GWI does not monotonically decrease or increase with increasing Doppler width. Except for the case of counter-propagating PDF with off-resonance driving field, at a suitable Doppler width one can obtain a gain maximum value much larger than that without Doppler broadening; especially in the situation of the resonant driving field, the co-propagating geometry leads to a larger GWI. In addition, for the counter-propagating geometry, when Doppler width is larger enough, GWI oscillation occurs, and the oscillation amplitude and region increase with increasing Doppler width. These conclusions are very different from that obtained in previous investigation (Lukin {\it et al}, {\it Laser Phys.} {\bf 6} 436 (1996)).     

Cu(CH3COO)2·H2O脱水反应动力学探讨

水合乙酸铜;;脱水动力学;热分析;等温等转化率法;Cu(CH3COO)2·H2O脱水反应动力学探讨     

Ni对Cu/ZnO基甲醇裂解催化剂的促进机制

通过XRD,BET,In-situ XPS等表征技术对Cu/ZnO基甲醇裂解制氢催化剂进行 了详细的研究。XRD结果表明,Cu-Zn合金的生成是Cu/ZnO基催化剂在反应初期快速 失活的主要原因;XRD,BET和N_2O滴定实验结果表明,Ni助剂可能是通过提高 Cu~0活性物种的分散度并维持Cu~0活性物种在催化反应过程中的稳定性而使 Cu/Zn/Ni催化剂的活性及稳定性大幅度提高。In-situ XPS结果表明,Ni助剂的加 入可以诱导Cu/Zn/Ni催化剂表面在甲醇裂解反应过程中出现Cu~+,从而由 Cu~0/Cu~+共同构成催化剂的活性中心,并最终导致Cu/Zn/Ni催化剂的高活性。     

一缩二乙醇二甲基丙烯酸酯对真丝接枝的反应性

研究了一缩二乙二醇二甲基丙烯酸酯在空气存在下,用过硫酸钾(KPS)在水液 中对真丝的接枝。对接枝的条件,如单体、引发剂、甲酸(FA)和乳化剂OP的浓度以 及温度和时间对接枝率的影响进行了测试。发现了较佳的接枝条件是：温度 = 80 ℃,时间 = 30 min,[KPS] = 1.85% (owm),[OP] = 1% (owf),[FA] = 0.2%。 接枝率的大小可以用单体浓度来调节,接枝活化能是86.94 kJ/mol。     

新型苯基取代杂萘联苯型聚芳醚的合成与性能

二氮杂萘酮;耐热性;溶解性;新型苯基取代杂萘联苯型聚芳醚的合成与性能